• Petite & Light – Only 64cm in height and 42 cm wide, 320gm
• Verification Method – Fingerprint and Card
• Card Option: MiFare & HID (made to order provide that the master reader is using the same card system)
• MiFare = MF1S50/S70, 13.56MHz, HID= HID 1325, 26-bits, 12KHz
• Memory: Not available
• Power Connection: Obtained from R2 unit
• Accessories available: One cable
• Installation distance: Maximum 3 meter distance between R2 and R2i, longer than that, signal might be lost
• One R2 can be connected to one R2i under standard installation. Unless a different controller is used
Why R2i is important?
• Complete fingerprint/card door access system can be achieved with installation of R2 and R2i • Record of IN/OUT movements is complete with this combination
• Economical solution for fingerprint IN and OUT reader
• Record of IN/OUT movements is complete with this combination
• Discourage tailgating
Note: R2i can only work with R2 units that have 11-pin connector in the rear.